Comfort Home Automation/ Security System Forums Home 
Home Search search Menu menu Not logged in - Login | Register
Comfort Home Automation/ Security System Forums > Third Party (interfacing to Comfort) > Zwave > Flash UCM05 with ZWave UCM

Flash UCM05 with ZWave UCM
 Moderated by: slychiu
 New Topic   Reply   Printer Friendly 
 Rate Topic 
AuthorPost
 Posted: Tuesday Nov 25th, 2008 11:06 am
   PM  Quote  Reply 
1st Post
palmlodge
Advanced Member
 

Joined: Thursday Dec 14th, 2006
Location: United Kingdom
Posts: 414
Status: 
Offline

  back to top


The z-wave UCM has the firmware flash pins - but no serial connection. Given what Cytech normally do with UCM's, you'd think the flash pins wouldnt be there if not possible.

I would also have to remove the daughterboard, and place a ethernet module there so it could act as the source to flash a UCM05 ?

Or is the flash pins there so the zwave can be flashed by a UCM05, but not the other way around ?

Possible ?

Last edited on Tuesday Nov 25th, 2008 11:07 am by palmlodge


 Posted: Tuesday Nov 25th, 2008 01:00 pm
   PM  Quote  Reply 
2nd Post
admin
Administrator


Joined: Saturday Mar 3rd, 2007
Location: Singapore
Posts: 1032
Status: 
Offline

  back to top

The Zwave programming pins are there to be flashed by  UCM05, it is not able to do the flashing even if you plug in the Ethernet module as the communications firmware on the serial interface side is different from the UCM05 or ethernet, it talks to Zwave instead


 Current time is 12:49 pm
Comfort Home Automation/ Security System Forums > Third Party (interfacing to Comfort) > Zwave > Flash UCM05 with ZWave UCM
 Top

UltraBB 1.17 Copyright © 2007-2008 Data 1 Systems