+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+--- Thread: TWS02 (/thread-1136.html)
- mrtae - 08-05-2008
Dear Chiu,
Would you mind to advice base on the attached drawing provide, it\'s the correct wiring connectivity been place?
Appreciate your advice, thank you.
Regards,
Tae
- slychiu - 08-05-2008
The Output connections are wrong
The centre 12V must go to the centre of the Comfort OP terminal block (12V) NOT -12V
The OP connection goes to the OP terminal of the Output terminal Block NOT +12V
regards