+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: CBus (https://www.comfortforums.com/forum-11.html)
+--- Thread: CBUS Flash (/thread-1407.html)
- palmlodge - 03-18-2009
In the lastest CBUS Toolkit, there is now an option to \'Flash\' a group - it appears to work just fine, and you can specify a delay between flashes.
Can you enable this functionality via Comfort - this can then be used as part of an Alert sequence to flash a light or group (ie all lights).
I use this now with a sequence of timers, but this functionality would remove the need for all of that - and CBUS can handle it.
Thanks
- admin - 03-21-2009
Do you and anyone know what Cbus commands are used to flash the lights?
- palmlodge - 03-22-2009
Aren\'t Cytech CBUS Enabled partners ? We cannot gain access to the protocol docs, but you can.
- admin - 03-22-2009
In theory, yes, but getting the right information from Schneider is not always so straightforward
- admin - 03-30-2009
According to Schneider in Singapore the flash command is only for diagnostic purposes. It is not defined in the CBus commands. It is done in the toolkit by sending a command on, delay, then Off delay then on using a program in the toolkit
Hence it is not possible to just send one command to do this
Comfort can do the same thing using timers