+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Firmware History (https://www.comfortforums.com/forum-60.html)
+---- Forum: Slave Firmware (https://www.comfortforums.com/forum-78.html)
+---- Thread: SEM 5.175 (/thread-1633.html)
- slychiu - 10-21-2009
- Slave Siren, Strobe and Speaker can be used on Slave
- Fixed Bug - initial value of Slave zones reported after reset to Comfort is wrong but subsequent activation is correctly reported. This causes incorrect initial report to Cbus etc
- Fixed Bug - Slave zones with Zone Types 17 to 31 all have Sensitivity highest ie 10 ms
- Fixed BUG - at reset Slave zones which are ON were reported as OFF then ON
- Slave Speaker Output enabled. Outputs same signal as Comfort. Requires Comfort 5.167 and above
- Slave STROBE Output enabled. Follows Strobe on Comfort. Requires Comfort 5.167 and above
- jorgecolaco - 01-15-2010
Hi,
Where can i download this firmware SEM 5.175?
In webpage there are only SEM firmware 5.163
I need to fix: \"Fixed BUG - at reset Slave zones which are ON were reported as OFF then ON\", the bug are hapenning in a home and we need to fix it.
Thank you,
Best regards,
Jorge Colaço
Segurant Technician
- slychiu - 01-15-2010
The firmware SEM 5.175 has now been updated at https://www.cytech.biz/semsep_firmware.html