UCM/Cbus Firmware 5.200, 5.202 - Printable Version +- Comfort Automation/ Security System Forums (https://www.comfortforums.com) +-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html) +--- Forum: CBus (https://www.comfortforums.com/forum-11.html) +---- Forum: UCM/CBUS Firmware (https://www.comfortforums.com/forum-85.html) +---- Thread: UCM/Cbus Firmware 5.200, 5.202 (/thread-1751.html)

- ident - 02-16-2010 UCM/Cbus 5.202 (12 January 2010) Supports new SIM Module with ST IC UCM/CBus 5.200 (13 October 2009) UCM/Cbus will not send date and time to C-bus when C-Bus changes date and time unless the date and time is changed, to prevent multiple date and gtime messages on C-Bus caused by either Comfort or C-Bus chaning date and time. Cbus Transmit Buffer increased from 254 to 600 bytes All Comfort zones reported at UCM/Cbus Reset. Note that the BUSY2 led will remain on while Comfort zones are being updated. This may take 30 seconds or so UCM/Cbus supports scanning of UCMs in Comfigurator 3.1.3 and reports Type, firmware version and revision Please note a bug has been discovered up to Cbus 5.217 Sending commands to other applications besides Lighting will update the counter related to the group address. Eg when you send a command to Cbus Trigger application at group address 1 to 255, then Counter 1 will change to 255 as well. The Counter should only be updated by the Lighting application This will be fixed in the next firmware version