+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: CBus (https://www.comfortforums.com/forum-11.html)
+---- Forum: UCM/CBUS Firmware (https://www.comfortforums.com/forum-85.html)
+---- Thread: UCM/CBUS 5.203 to 5.208 (/thread-1752.html)
- ident - 02-16-2010
UCM/CBUS 5.203 (Beta) firmware allows the Security Armed Mode to be sent to Cbus when Comfort is armed, with values 01 = Away, 02 = Night, 03 = Day, 02= vacation. Previous UCM/Cbus firmware sent either 01 (armed) irrespective of what mode Comfort is armed to.
However C-Bus devices report 01 = Fully Armed, 02 = Partially armed, 03 , 04 = Armed to Special Mode.
The attached .cbf file can be used to upgrade UCM/Cbus firmware via UCM05, UCM/232, UCM/USB or UCM/Ethernet
Note: UCM/Cbus 5.203 does not work with new Cbus SIM Daughterboard with ST7 micro
- slychiu - 12-31-2010
UCM/Cbus 5.208
- Security Armed State will have values 1 to 4 depending on security mode instead of common 1 when armed.
- If zone is bypassed at UCM/Cbus reset, this is reported to to Cbus.
- Multiple Cbus messages can be received and handled.
- Existing Line cut, AC Failure and low battery alarms are notified to C-Bus when C-Bus is connected to Comfort.
- Zone states are reported to Cbus when Cbus is connected
- Faster initialisation of Cbus interface especially when the Security Application is not present on the C-Bus (eg C-Touch)
- Fixed bug when Cbus addresses > 128 not reported correctly
- Added STOP ramp SAL command, handle Label DLT message
- Messages to C-Bus larger than 45 bytes (concatenated messages) are aborted in keeping with the Cbus serial interface spec.
- Security Application Password Good/Bad supported
- Sending commands to other applications besides Lighting will update the counter related to the group address.
This firmware UCM 5.208 and below should onlybe used with SIMs labelled 1223/x, and 1151/x as shown below
