+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Velbus (https://www.comfortforums.com/forum-88.html)
+--- Thread: Velbus to Cytech - RS232 Cable (/thread-1812.html)
- segurant - 04-12-2010
After a few tries we make it work,
This is the sucessfull wire connections to connect both UCM\'s by a RS232 cable
UCM/Velbus (Cytech) to VMB1RS (Velbus)
Change Pin\'s
2 -> 3
3 -> 2
4 -> 6
6 -> 4
7 -> 8
8 -> 7
The colors diagram may be diferent in your cable, so check the pin\'s first.
- admin - 04-12-2010
Thanks for the information, segurant. We have updated the advise in the main topic introducing the UCM/Velbus.
The hardware flow control pins are required by the VMB1RS in order to send out data to UCM/Velbus.
- slychiu - 06-21-2010
The UCM/Velbus in future will be supplied with a RS232 Male connector and a Male to Female straight RS232 cable so that it can be directly connected to the VMB1RS
The plug in RS232M can be plugged in to the UCM/Velbus base board in place of the RS232F
Those who have a trial unit UCM/Velbus can request the RS232M from us at no charge
The plug in RS232M board is shown below