+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Software Applications (https://www.comfortforums.com/forum-4.html)
+--- Forum: Comfigurator (https://www.comfortforums.com/forum-20.html)
+---- Forum: Comfigurator 3.x Old Versions (Archive) (https://www.comfortforums.com/forum-87.html)
+---- Thread: Comfigurator 3.2.4 Beta (/thread-2025.html)
- ident - 10-30-2010
New Features
- KT03 Save Template and Load template Buttons next to Write to EEPROM and Read from EEPROM allows KT03 configuration to be imported and exported to other files
- Comfort Bus Monitor and IR Learner in Tools have been incorporated into Comfigurator instead of being stand-alone programs so that the Connecction settings of Comfigurator can be used. However Comfort Bus Monitor cannot be used for UCM/Ethernet due to limitations of the buffer size of the Ethernet Tibbo module.
- Universal UCM support has been added but not complete.
- In KT03, changing the Font size of text in Button Elementcaused exception
- For Velbus, if a blank EEPROM is used in U2, an exception occured aftre learning when writing to EEPROM
- Responses referenced by KT03 buttons were not shown as regerenced in blue
- In KT03 Comfigurator, Input zones allowed Zones 1 to 64 but not RIO inputs 129 to 248. Now RIO zones can be referenced
- KT03 simulator Home and Back jumps did not work correctly
- When Say Word Action is the last action in the Response, Comfigurator did not append another 255 to end the Response so the Response may continue to the next line.
- When Send RS232 is the last action in the Response, Comfigurator did not append another 255 to end the Response so the Response may continue to the next line
- IR Receive Responses - if assigned to NULL, called Response 255 if the IR signal is received.Null Response is correctly addressed now.
Branch Actions were introduced in Comfort I firmware 4.232. This allows Comfigurator 3 to code If/Then actions correctly. Comfigurator 2 has a checkbox called \"Use Branch Actions\" in Modules & Settings. This checkbox is not found in Comfigurator 3 as it will automatically apply Branch Actions when the Comfort I firmware is 4.232 and above.
If you are converting a comfigurator 2 file for Comfort I to Comfigurator 3, and if the Comfort I firmware is 4.232 and above, please check the \"Use Branch Actions\" box on Comfigurator 2 and save BEFORE conversion to Comfigurator 3 otherwise an Exception will occur when opening in Comfigurator 3
If the Comfort I firmware is lower than 4.232 uncheck Use Branch Actions in Comfigurator 2 Modules and Settings before conversion to Comfigurator 3
Please download beta version from https://www.cytech.biz/comfigurator.html
Please report any bugs to support@cytech.biz