+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Velbus (https://www.comfortforums.com/forum-88.html)
+--- Thread: Support for new Velbus modules (/thread-2151.html)
Pages:
1
2
- bs85 - 01-27-2011
When are you going to add support for the new Velbus modules?
VMB4RYLD - 4 Channel Relay Module
VMB4RYNO - 4 Channel Relay Module
VMB4DC - 4 Channel 0-10V Controller
VMB1LED - LED Dimmer Module
- ident - 01-28-2011
The 2 relay modules are similar to the exiting relay modules which we support, so it should be quite simple to add support for these.
The 0 to 10V and the LED dimmer will need further study
Do you have a pending requirement to use these new modules?
- bs85 - 01-29-2011
I have some LED dimmer modules on order.
So support for these would be appreciated.
- bs85 - 02-05-2011
I have received a couple of VMB1LED modules.
When doing a learn with the VMB1LED modules connected it fails with a No response to Velbus Learn Request.
When added manually as VMB1DM modules they work OK.
- slychiu - 02-07-2011
Comfigurator does not recognise the module type of VMB1LED because it was introduces after the UCM/Velbus became available but as most of the commands are the same as VMB1DM it should work
In future we will add support for the new modules. We are waiting for our order of the modules from Velleman so we can test
- bs85 - 04-07-2011
Any updates on adding the newer modules?
- ident - 04-18-2011
UCM/Velbus 5.229 can be downloaded from the website at https://www.cytech.biz/ucmvelbus_firmware.html which supports the new Velbus Modules
This is labelled a Beta version at the moment
It fixed the problem in previous versions that sometimes when learning the Velbus network, an error message is seen, even though the network is scanned correctly
- bs85 - 04-18-2011
Got 5.229 firmware installed and still getting the \"No response to Velbus Learn request\" every time a learn is run.
- ident - 04-19-2011
You are right, there is still a problem which is being looked into
- ident - 04-20-2011
The new Velbus 5.230 beta firmware can be downloaded from the website which fixes the error when learning
https://www.cytech.biz/ucmvelbus_firmware.html