+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html)
+--- Thread: Status LEDs (/thread-260.html)
- cgiltrow - 10-30-2006
Hi,
I have a Comfort Ultra I Action 4.233.
I have four spare outputs on a RIO and I would like to use them for Status LEDs on the main panel (which is where the RIO is). I connected 4 LEDs (with 2.0k resistors in series) and configured the outputs as status outputs in Comfigurator>Security>Status.
After downloading the LEDs are constantly on and not representing the status correctly.
Any suggestions?
Thanks.
- slychiu - 10-30-2006
I am afraid you cannot use RIO outputs for indicating the onboard status leds with the current firmware
That function was done in the very old days and had a check on the output number of 64. It was not updated when the RIO/SCS was introduced. If you were to upgrade your firmware in future (for other reasons) this should have been implemented