+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Zwave (https://www.comfortforums.com/forum-62.html)
+--- Thread: Connecting UCM/Eth2 along with UCM/ZWave to Comfort CPU (/thread-2736.html)
- Vangelis - 02-17-2012
Just reading up on how to connect the Eth2 and ZWave UCMs to the main Comfort CPU board.
Would appear that J6 (RS485) is used on the Comfort CPU board, however either J2 or J2A are used on the UCMs to connect to this port.
My question is, how do I connect 2 UCMs to one J6 (RS285) port on the Comfort CPU board?
- bs85 - 02-17-2012
Daisy chain them.
J6 Comfort to J2 on the Ethernet UCM
J2A Ethernet UCM to J2 on the Z-Wave UCM
- Vangelis - 02-20-2012
I had hoped it would be as easy as that
Thanks for the quick response.