+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Questions on Installation and Connection (https://www.comfortforums.com/forum-123.html)
+--- Thread: Bosch Blue line Gen2 PIR wiring advice (/thread-3669.html)
- ident - 01-03-2014
There is an errror on the post
http://www.comfortforums.com/forum16/3667.html
The image is missing and the post cannot be edited
The double EOL connection can be found in the Installation manual figure 2.11 as shown below
This shows how to connect the alarm and tamper contacts with 2 EOL resistors
- Guest - 01-03-2014
Thank you for your reply. I need to know how to apply these resistors to the 6 connections that I have available on the PIR, which are as follows:
-
+
NC
NC
T
T
Thanks again
Avney
- tech07 - 01-04-2014
The connections for the 2 resistors is shown in the jpg diagram
If you cannot see the jpg, you have to download the attachment
4K7 is connected between the two NC
2K7 is connected from NC to T in series
Or wait for wiredhome diagram in http://www.comfortforums.com/view_topic.php?id=3667&forum_id=16&jump_to=16138#p16138
- ident - 01-05-2014
Siamak has the right connection more clearly shown in http://www.comfortforums.com/forum16/3667.html
For some reason I cannot see any button to reply to that topic