+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: CBus (https://www.comfortforums.com/forum-11.html)
+---- Forum: UCM/CBUS Firmware (https://www.comfortforums.com/forum-85.html)
+---- Thread: UCM/CBUS 7.041/ 7.045 Beta (/thread-3753.html)
- ident - 04-04-2014
UCM/CBus 7.041 (Beta) can be downloaded from https://www.cytech.biz/product_details.php?item_id=233
Known Issues
- Sending C-Bus commands to Cbus by Response Wizard may not work for some UCM IDs eg ID 8
- Ucm/cbus could not initialise if the cbus wires are plugged in after reset.
- Rare occurrence where UCM/CBUS resets if a C-Touch or device which does not support the security application is not installed, and there is a zone change
- Cbus group address updates counter even when no change in value so scenes can work
- Able to upgrade to UCM/Cbus2. Older UCM/Cbus firmware must upgrade to this firmware before upgrading to UCM/CBUS2