+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Comfort Installation and Programming Guide (https://www.comfortforums.com/forum-124.html)
+---- Forum: Responses and Actions (https://www.comfortforums.com/forum-92.html)
+---- Thread: IR Programing (/thread-4577.html)
- Swiss-Toni - 12-10-2016
It\'s been a long time since i have setup a IR, I have copied the TX from the remote via the ethernet UCM, that was fine.
The issue is when IR is connected to an output I cannot find the files I need to associate with responces in \"Responce Wizard\"
Cannot remember how I done it before, Am I missing out on the programming as cannot find in manual for programing IR in \"Responces\"
hock:- slychiu - 12-10-2016
when you learn an ir code it goes into the IR Library
You have to go to Configuration > IR Transmit Codes to select the IR code that you learned
The pulldown menu allows you to select the code that you learned
see the topic here
How to Send Infrared Signals through any Output
http://comfortforums.com/forum126/4395.html
- Swiss-Toni - 12-10-2016
Thankyou for your responce, that was what I was doing!I have found that the IR will not work with my LEM01 and had to move it to No 16 Output in the main panel and it worked as it should.
Is their any known issues with using IR conected to Outputs beyond output 16?
Prior to putting it on Output 16 I tried to have connected to Output 21.
- slychiu - 12-10-2016
Output 16 is on LEM01 not on main panel
Output 21 should be on the Slave (SEM)
Do you mean it could not work on the SEM? what is the firmware of the SEM?
- Swiss-Toni - 12-10-2016
I stand corrected, It does not work on the SEM the firmware version is curently 6.068
(Also Output board working fine with relays)
- slychiu - 12-12-2016
There should be no problem with SEM 6.068 sending IR codes
Can you send your cclx file to support@cytech.biz?
- Swiss-Toni - 12-15-2016
Hi SlyChiu
I noticed quite a few issues on my system where the IR was concerned and downgraded the use of comfigurator until it was working fine, Although admittedly I have not moved the IR back to the SEM as everything is working (if it isnt broke dont fix it rule) Not sure what was causing the issues as KT03 (the output signals)keypads were affected as well, I think there must have been a corrupt file somewhere along the line.
- slychiu - 02-04-2024
Saved Infrared Codes may be found in the folder C:\\ProgramData\\Cytech\\Comfigurator\\ifr