+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Firmware History (https://www.comfortforums.com/forum-60.html)
+---- Forum: Slave Firmware (https://www.comfortforums.com/forum-78.html)
+---- Thread: Slave Firmware 7.141 (/thread-4880.html)
- slychiu - 04-15-2018
Bugs Fixes
- Copy ID could not set ID to 5
- Slave zone analog value was not correct Not affect 7.117
- Strobe did not work on slave
- Fixed Intermittent Communications Failure which may occur every day or every few days, applicable for Slave PCB hardware without Zone EOL shunts
- Swiss-Toni - 04-15-2018
Could this be a cause of what was going on with SEM in topic http://www.comfortforums.com/forum91/4868.html
As i have been unable to resolve the issue (to be honest I gave up and move the pirs to zones 1 to 16)
- slychiu - 04-16-2018
This should not be related to your problem which is zones becoming on and off when connected to the LEM
The issue with the SEM firmware is occasional Communications Failure
However there is no harm in upgrading to the latest SEM firmware to see if it makes any dofeerence