+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Questions on Programming Comfort (https://www.comfortforums.com/forum-83.html)
+--- Thread: Comfigurator losing EOL setting (/thread-5375.html)
- Majik - 03-13-2022
Using Comfigurator v 3.13.7.0 to program a recently upgraded system with a CM9001 board, which has the EOL settings programmed, rather than as hardware shunts.
I find that, quite often, Comfigurator loses the Double EOL setting and reverts all zones back to \"No EOL\", which is a problem if I don\'t notice it\'s done this, and upload the configuration, only for the system to erupt with Tamper alerts.
I\'ve not yet worked out what sequence of usage causes this.
Cheers,
Keith
- slychiu - 03-13-2022
I have not encountered this. It may be doe to scanning for modules not getting the correct info. Defaulti s Shunts. Watch out for this after log in as there is an automatic scan for modules
- Home - 08-08-2024
Yes have experienced this on many occasions
I expect that pressing the update defaults button will fix it !