Comfort 1 to SEM01-M2 and LEM01-M2 compatability - Printable Version +- Comfort Automation/ Security System Forums (https://www.comfortforums.com) +-- Forum: Support (https://www.comfortforums.com/forum-2.html) +--- Forum: Problems & Troubleshooting (https://www.comfortforums.com/forum-36.html) +--- Thread: Comfort 1 to SEM01-M2 and LEM01-M2 compatability (/thread-543.html)

- tomekajja - 04-05-2007  Hi there,  I have a comfort 1 with the firmware \"Outside 4.204\". Recently I added  a LEM01 and then a SEM01-M2. All these are working OK.    My problem is that when I add the LEM01-M2 the comfort does not see  the zones opening or closing. However when I unplug the Ribbon cable  connector to the SEM01-M2 the comfort complains saying \"Zone 25  Trouble….. etc\" . This indicates that the comfort is aware that the  zones exist but is not seeing the activation of the zones.    Does this mean I need to upgrade the comfort main board firmware or  entire comfort to a G2 to be able to see these zones.    Please advice.    Regards    TOM