+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Questions on Programming Comfort (https://www.comfortforums.com/forum-83.html)
+--- Thread: Zone displaying on Keypad (/thread-5637.html)
- DavidJ - 05-26-2025
My system just reset itself and said something about \"key\" when it did so. I have no idea why this happened and need to look at as a next issue but currently the keypad shows each zones as it becomes active. Initially (after reset) it was calling out each zone (like walk test) but I seem to have resolved that. Now pad just showing each zone as they activate. Any advice on how to turn this off?
- slychiu - 05-27-2025
Something may have changed in the programming or the eeprom. I suggest to open a default template and write to comfort. Then see if the problem still occurs. If so it ay be a hardware issue. If not then open your original cclx file and write to comfort again, and see if the problem has come back
- DavidJ - 05-27-2025
Great will try that.