+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Support (https://www.comfortforums.com/forum-2.html)
+--- Forum: Comfort Installation and Programming Guide (https://www.comfortforums.com/forum-124.html)
+---- Forum: Comfort Installation Instructions (https://www.comfortforums.com/forum-127.html)
+---- Thread: ID 0 now appears on UCM list when loading a customers .cclx file (/thread-5873.html)
ID 0 now appears on UCM list when loading a customers .cclx file - Home - 06-08-2026
We did an upgrade to a main CPU a couple of years back using Comfig 3.14.14.0 all went well and its been fine.
I have just re-opened the file using Comfig 3.14.14.0 then gone to alter some settings. When I go to modules tab UCM - module ID 0 appears.
If I open the same file in Comfig 4.0.4.0 there is no ID 0 and the listing is by my reckoning correct.
---------------------------------------------------
We have only used Comfig 4 on new installations.
What should I do in this situation ?
I will be attending site tomorrow to replace a faulty CBUS UCM so will need to know which way o proceed
Thanks
RE: ID 0 now appears on UCM list when loading a customers .cclx file - slychiu - 06-08-2026
Use Comfigurator 4.0.4 which does not have the ID0 problem. It should not cause any probkems
v3.14.,14 can be used for very old systems
RE: ID 0 now appears on UCM list when loading a customers .cclx file - Home - 06-08-2026
(06-08-2026, 10:10 AM)slychiu Wrote: Use Comfigurator 4.0.4 which does not have the ID0 problem. It should not cause any probkems
v3.14.,14 can be used for very old systems
Thanks for swift reply - fingers crossed for tomorrows upgrade.