Comfort Automation/ Security System Forums
Companion/SideKick to Comfort - Printable Version

+- Comfort Automation/ Security System Forums (https://www.comfortforums.com)
+-- Forum: Third Party (interfacing to Comfort) (https://www.comfortforums.com/forum-5.html)
+--- Forum: Miscellaneous Interfaces (https://www.comfortforums.com/forum-47.html)
+---- Forum: Companion (https://www.comfortforums.com/forum-35.html)
+---- Thread: Companion/SideKick to Comfort (/thread-594.html)



- mgfair - 05-06-2007

Can SideKick be connected to Comfort through the RS232 serial interface of CWM?  

Alternatively,if the UCM/Ethernet board is used to connect rather than the CWM, I assume that there is no serial connection between Comfort and SideKick, if what are there any issues with this?



- Guest - 05-06-2007

That port for the CWM is meant for a dialup modem connection.

The UCM/Ethernet is used similar to a serial UCM. What issues do you refer to? I do not see any issues with this so far.



- mgfair - 05-06-2007

Thanks for the reply.  I do not know if there are any issues (eg reliability, flexibility, functionality) - hence - the question.

Baiscally, I am trying to determine which UCM(S)/modules I need to connect Comfort to:

1. SideKick;

2. The Gigabit network around my home; and

3. The internet.

Mark



- ident - 05-06-2007

If you can get the UCM05 serial interface near the Sidekick, then that would be a cheaper option than the UCM/Ethernet, as Rs232 can only go about 10 meters

To connect to the Ethernet/Internet you need the UCM/Ethernet



- mgfair - 05-06-2007

Thanks but your reply does not really answer my questions, see above.  I asked about reliability, functionality etc.  Let me ask another way, is a short run RS232 serial connection a more stable solution than ethernet? (note SideKick only has 1 network port).

Anyway - I suppose it is possible to have the UCM/Audio and either the UCM/Ethernet or CWM installed into Comfort?  The RS232 on the UCM/Audio can be used to connected to SideKick (with audio) leaving SideKick\'s only network adapter to connect to my ethernet switch.

M



- Guest - 05-07-2007

Both should work as well.

Yes, you can have the configuration as you stated. Comfort allows the combination of up to 8 UCMs (of any type) in its system.