06-02-2008, 07:28 AM
Two bits of good news and a question......
(no, not the title for a new film!)
Firstly, I have solved my problem with the application falling over. I\'m mentioning it here, as the solution might be useful to others reading events from the Ethernet UCM. By default, the Ethernet connection is configured to time out after 5 minutes - causing a forced reset after five minutes of inactivity. Using DS Manager, it is very easy to change the setting to \"0 - Disabled\". Once that is done, the timeout goes away.
Secondly, I have discovered that my original worry about the status reporting switching off at midnight was unfounded. Last night, my application carried on past midnight and was still happily recording events this morning. I can only assume that the cutting off at midnight arrived in a later version (mine is 4.206 / 5.063).
The question comes from that second point. I have a version of the Serial Command Interface document which has 10 May 2007 as the most recent date in the Change History. Is it possible to obtain an older version of the document which ties in with what is actually supported by my Comfort/UCM versions? I appreciate that I might be asking a lot there!
Thanks, Nick
(no, not the title for a new film!)
Firstly, I have solved my problem with the application falling over. I\'m mentioning it here, as the solution might be useful to others reading events from the Ethernet UCM. By default, the Ethernet connection is configured to time out after 5 minutes - causing a forced reset after five minutes of inactivity. Using DS Manager, it is very easy to change the setting to \"0 - Disabled\". Once that is done, the timeout goes away.
Secondly, I have discovered that my original worry about the status reporting switching off at midnight was unfounded. Last night, my application carried on past midnight and was still happily recording events this morning. I can only assume that the cutting off at midnight arrived in a later version (mine is 4.206 / 5.063).
The question comes from that second point. I have a version of the Serial Command Interface document which has 10 May 2007 as the most recent date in the Change History. Is it possible to obtain an older version of the document which ties in with what is actually supported by my Comfort/UCM versions? I appreciate that I might be asking a lot there!
Thanks, Nick