Comfort Automation/ Security System Forums › Products › UCMs
Upgrading Comfort II Flash firmware by UCM Programming Cable

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Upgrading Comfort II Flash firmware by UCM Programming Cable
slychiu Offline
Administrator
*******
Posts: 5,950
Threads: 871
Joined: Apr 2006
Reputation: 2
#7
10-24-2025, 07:01 AM
Note the UCM/ETHxx cannot be used to upgrade the firmware on its own Comfort controller. You can use a UCM/USB to do  this. 

Or you can use UCM ethernet to  upgrade the firmware of another Comfort controller connected to the ucm firmware programming cable as long as the  UCMs CM9001 controller is not being upgraded

Again, the UCM/USB can upgrade CM9001 controller in all siuations so please use that
Website Find
Reply


Messages In This Thread
[No subject] - by - 11-02-2008, 07:20 AM
RE: Upgrading Comfort II Flash firmware by UCM Programming Cable - by slychiu - 10-24-2025, 07:01 AM
[No subject] - by - 01-03-2010, 02:19 AM
[No subject] - by - 01-03-2010, 02:22 AM
[No subject] - by - 05-31-2011, 11:07 AM
[No subject] - by - 05-31-2011, 12:29 PM
[No subject] - by - 06-28-2012, 04:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)