06-27-2009, 06:59 PM
I\'ve noticed on a few occasions that the Counter values on Comfort, populated by CBus, change after a system reset.
When CBus populates counter values according to light levels, these levels are lost if you do a system reset on the Comfort side. Once the system return, the values in the counters reflect either 0 or 255. Below is an example of a light that was dimmed at 55%. I then did a system reset and found the coresponding counter to be 255 instead. Once the light changes level it will correct itself but still, is this designed like this or is there a bug in the system somewhere...
> C?6B
< C?6BFF
On the CBus side, PICED return the following in the Load Status:
Group 107 55%
When CBus populates counter values according to light levels, these levels are lost if you do a system reset on the Comfort side. Once the system return, the values in the counters reflect either 0 or 255. Below is an example of a light that was dimmed at 55%. I then did a system reset and found the coresponding counter to be 255 instead. Once the light changes level it will correct itself but still, is this designed like this or is there a bug in the system somewhere...
> C?6B
< C?6BFF
On the CBus side, PICED return the following in the Load Status:
Group 107 55%