Comfort Automation/ Security System Forums › Third Party (interfacing to Comfort) › Access Control
Fingerprint reader

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Fingerprint reader
technik23 Offline
Junior Member
**
Posts: 36
Threads: 8
Joined: Mar 2008
Reputation: 0
#1
09-08-2009, 06:18 PM
We have 2 installations with FP readers and I cannot get either of them to run user responses.  The fingerprints register OK but nothing happens when the FP is read by the system

The FPs are at present all Masters, could this have something to do with it.  The appropriate leds are flashing.  The UCM was found by Comfigurator 3 but only has an other type as there isn\'t an Access type.  Ther seems no way to test it other than run responses.

Thanks

Find
Reply


Messages In This Thread
[No subject] - by - 09-08-2009, 06:18 PM
[No subject] - by - 09-09-2009, 11:41 AM
[No subject] - by - 09-09-2009, 11:46 AM
[No subject] - by - 09-10-2009, 01:24 AM
[No subject] - by - 09-10-2009, 03:49 PM
[No subject] - by - 09-11-2009, 02:37 AM
[No subject] - by - 09-24-2009, 02:56 PM
[No subject] - by - 09-24-2009, 11:15 PM
[No subject] - by - 09-26-2009, 02:25 PM
[No subject] - by - 09-27-2009, 03:51 AM
[No subject] - by - 09-27-2009, 03:52 AM
[No subject] - by - 09-27-2009, 03:59 AM
[No subject] - by - 09-28-2009, 10:49 AM
[No subject] - by - 09-28-2009, 12:38 PM
[No subject] - by - 09-28-2009, 12:40 PM
[No subject] - by - 09-28-2009, 12:51 PM
[No subject] - by - 09-28-2009, 12:58 PM
[No subject] - by - 09-28-2009, 01:11 PM
[No subject] - by - 09-28-2009, 01:26 PM
[No subject] - by - 09-28-2009, 01:41 PM
[No subject] - by - 09-28-2009, 02:12 PM
[No subject] - by - 09-29-2009, 08:38 AM
[No subject] - by - 09-29-2009, 08:44 AM
[No subject] - by - 09-29-2009, 12:20 PM
[No subject] - by - 10-02-2009, 03:20 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)