Comfort Automation/ Security System Forums › Support › Firmware History › Comfort Firmware v
Ultra II Installation of MPU01

Thread Closed 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Ultra II Installation of MPU01
Ingo Offline
UCM Pi Users
Posts: 620
Threads: 62
Joined: Jan 2007
Reputation: 2
#11
08-24-2010, 03:57 PM
Can I upgrade my MPU01 while it\'s plugged into the Comfort II Main board? Will I damage anything if I connect the programming cable to the MPU01, shunt PP2 and then upgrade it via my UCM/Ethernet?

The reason for asking is if I have to dismantle my Slave board and move all the wires and stuff one more time I am surely going to break something soon.

Ingo
Find
Thread Closed 


Messages In This Thread
[No subject] - by - 01-10-2010, 04:44 PM
[No subject] - by - 01-11-2010, 02:44 AM
[No subject] - by - 01-11-2010, 07:52 AM
[No subject] - by - 01-16-2010, 10:28 PM
[No subject] - by - 01-17-2010, 09:47 AM
[No subject] - by - 01-17-2010, 10:09 AM
[No subject] - by - 01-17-2010, 10:18 AM
[No subject] - by - 01-17-2010, 02:07 PM
[No subject] - by - 01-17-2010, 02:36 PM
[No subject] - by - 01-17-2010, 06:22 PM
[No subject] - by - 08-24-2010, 03:57 PM
[No subject] - by - 08-25-2010, 12:56 AM
[No subject] - by - 08-25-2010, 04:58 AM
[No subject] - by - 08-25-2010, 03:59 PM
[No subject] - by - 08-27-2010, 03:19 PM
[No subject] - by - 08-27-2010, 04:02 PM
[No subject] - by - 08-28-2010, 05:15 AM
[No subject] - by - 08-28-2010, 10:38 AM
[No subject] - by - 08-29-2010, 05:04 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)