UCM/Ethernet Fails to Connect
|
UCM/Ethernet Fails to Connect
|
10-01-2011, 03:05 PM
I have just installed a UCM/ETH02. I have used the TIBBO DS Manager to se the IP address and saved. I run comfigurator and login but if I try to read andthing from comfort I cannot and tells me the UCM has failed to connect. If i try to log in again I cannot. If i leave it a while it starts the process above again. Also gices codes that I don\'t reconise, see attached. Any ideas
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
[No subject] - by - 10-01-2011, 05:49 PM
[No subject] - by - 10-02-2011, 02:11 AM
[No subject] - by - 10-02-2011, 09:03 AM
[No subject] - by - 10-02-2011, 09:15 AM
[No subject] - by - 10-02-2011, 09:27 AM
[No subject] - by - 10-02-2011, 09:34 AM
[No subject] - by - 10-02-2011, 09:39 AM
[No subject] - by - 10-02-2011, 09:46 AM
[No subject] - by - 10-02-2011, 09:48 AM
[No subject] - by - 10-02-2011, 09:56 AM
[No subject] - by - 10-02-2011, 10:23 AM
[No subject] - by - 10-02-2011, 02:08 PM
[No subject] - by - 10-02-2011, 02:11 PM
[No subject] - by - 10-02-2011, 02:19 PM
[No subject] - by - 10-03-2011, 07:23 AM
[No subject] - by - 10-03-2011, 09:45 AM
[No subject] - by - 10-03-2011, 10:10 AM
[No subject] - by - 10-03-2011, 12:09 PM
[No subject] - by - 10-03-2011, 12:50 PM
[No subject] - by - 10-03-2011, 07:01 PM
[No subject] - by - 10-04-2011, 04:57 AM
[No subject] - by - 10-04-2011, 07:56 AM
[No subject] - by - 10-04-2011, 10:10 AM
[No subject] - by - 10-05-2011, 06:53 PM
[No subject] - by - 10-06-2011, 06:59 PM
[No subject] - by - 10-06-2011, 07:01 PM
[No subject] - by - 10-07-2011, 02:26 AM
|
