11-21-2011, 06:51 AM
[user=4349]lwillerton[/user] wrote:
This is good but it looks like you selected the option Upgrade by Programming Cable
This is for upgrading another module with the UCM. It cannot be used for upgrading the same UCM. To upgrade a UCM using this method you need to use another UCM
If you want to upgrade the UCM itself then you must use the method Upgrade by Direct connection to PC
This is why you had the error
The upgradiing procedure is fully described in the UCM Manual from https://www.cytech.biz/ucm_manual.html
Do read the chapter on firmware upgrading before you attempt it otherwise you may end up corripting the firmware
Quote:Hi IdentYou tried to upgrade UCM6.002 to 6.008
I was just trying to do actions to talk to the system to see if it failed to communicate. I did a lot of system info requests as well and uploaded a config change.
I have alway intended upgrading the ETH UCM to 6008 from 6002 to see if this makes the ETH comms more stable and though I could do this by selecting upgrade firmware. When I tried it says update failed with errors.
This is good but it looks like you selected the option Upgrade by Programming Cable
This is for upgrading another module with the UCM. It cannot be used for upgrading the same UCM. To upgrade a UCM using this method you need to use another UCM
If you want to upgrade the UCM itself then you must use the method Upgrade by Direct connection to PC
This is why you had the error
The upgradiing procedure is fully described in the UCM Manual from https://www.cytech.biz/ucm_manual.html
Do read the chapter on firmware upgrading before you attempt it otherwise you may end up corripting the firmware