04-15-2012, 10:11 PM
Hi,
Was doing a bit of tidying up inside my panel today, mainly 12v wiring etc, and once I finished, I disconnect the 4 pin cable of my ucm to re organise the cable and reconected it again.
Since the, I cant connect, and keep getting the message no respponse from ucm!
I have changed nothing on my data cabling etc, no changes to umc ID\'s etc and my ucm velbus is working fine.
The symptoms are as follows:-
1) D2 and d3 leds flashing ok. I get ocasional d1 led flash (for about 2 sec), followed by 3 flashes of d103.
I have reset both comfort and ucm/eth, and no change. I can ping the ip of my ucm and get a successfull response.
Issue occurs whith both iphone and comfigurator on local network.
I tried a number of other things to clear the clutter so to speak, i disconnected all other ucm devices, dicsonnedted keypads and scs\'s all at once, and disconnected anything on the 12v power system leaving only the ucm/eth powered up via the 4 pin cable to the main board.
Nohting has worked... Its an odd one, as I definately did not change anything config wise, and the wiring to the ucm is simply a direct cable connection.
I\'ve taken a short clip of the ucm led status, which can be viewed on the link below
https://docs.google.com/open?id=0B1zlDoq...nR6WDVndEU
Any advice apprecaited.
Regards,
Eamon
Was doing a bit of tidying up inside my panel today, mainly 12v wiring etc, and once I finished, I disconnect the 4 pin cable of my ucm to re organise the cable and reconected it again.
Since the, I cant connect, and keep getting the message no respponse from ucm!
I have changed nothing on my data cabling etc, no changes to umc ID\'s etc and my ucm velbus is working fine.
The symptoms are as follows:-
1) D2 and d3 leds flashing ok. I get ocasional d1 led flash (for about 2 sec), followed by 3 flashes of d103.
I have reset both comfort and ucm/eth, and no change. I can ping the ip of my ucm and get a successfull response.
Issue occurs whith both iphone and comfigurator on local network.
I tried a number of other things to clear the clutter so to speak, i disconnected all other ucm devices, dicsonnedted keypads and scs\'s all at once, and disconnected anything on the 12v power system leaving only the ucm/eth powered up via the 4 pin cable to the main board.
Nohting has worked... Its an odd one, as I definately did not change anything config wise, and the wiring to the ucm is simply a direct cable connection.
I\'ve taken a short clip of the ucm led status, which can be viewed on the link below
https://docs.google.com/open?id=0B1zlDoq...nR6WDVndEU
Any advice apprecaited.
Regards,
Eamon