Comfort Automation/ Security System Forums › Third Party (interfacing to Comfort) › Access Control
UCM access not running responses

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
UCM access not running responses
BernardW Offline
Junior Member
**
Posts: 9
Threads: 3
Joined: Aug 2012
Reputation: 0
#1
09-12-2012, 12:53 PM
Using UCM access 5.204 The fingerprint reading is a bit unreliable but the main problem is that responses don\'t run. I\'m not convinced that the FP reader is talking to the UCM.
I seem to remember from a previous install that the tiny DIP switches on the SOHO control unit could give a problem.
Find
Reply


Messages In This Thread
[No subject] - by - 09-12-2012, 12:53 PM
[No subject] - by - 09-12-2012, 01:28 PM
[No subject] - by - 09-12-2012, 02:29 PM
[No subject] - by - 09-13-2012, 01:38 AM
[No subject] - by - 09-13-2012, 12:23 PM
[No subject] - by - 09-13-2012, 02:54 PM
[No subject] - by - 09-17-2012, 11:03 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)