Login

***ident*** · (This post was last modified: 08-30-2013, 04:53 AM by ident.)

Comfort Firmware 7.013 Beta has the following changes;

Scan for modules will report modules that are not currently polled by Comfort. The u? Reply has been extended to u?nnTTVVRRFF where nn = id of module, TT = Product Type, VV = Firmware Version, RR = firmware revision, FF = 00 for ID good and FF for ID bad or not polled. Module that does not reply will have a report u?nnFFFFFFFF.
Added action code Get Parameter 73,30 = Get Last Security Mode. Can be used to check what was the last security mode which the system was armed to.
Added Action 120 Compare sensor compare inputvalue against sensor.
Added action 153 load user value 2 bytes
Added 2 byte Conditional branch actions Action 184 = Branch if equal, 185 = Branch if <>, 186 = Branch if >=, 187 = Branch if <, 188 = Exit if equal. The 2 byte values are signed ie can be positive or negative using two complement notation.
Report counter broadcast 2 bytes when any counter changes
Fixed BUG reset action 118 reset ID may not have worked
Fixed BUG from ULT 7.009 - false Communications Failures may be sometimes reported
Fixed BUG when trouble happens while in keypad menu and is restored before exit, KP06 and KT03 trouble remains and cannot clear. Bug Did not affect KP04 and KP03
Logic Engine does not require Engineer sign in to upgrade firmware Does not affect other Comfort models

Known Bugs

Related to UCM/GSM. SMS messages do not show Zone Names correctly
Scan for Modules where the module firmware does not support the scan command will report wrongly as module not found
Copy Counters action does not work
Say Words action does not work using a UCM Do action command
if actions Bypass, Unbypass Key arm, Auto arm or Activate Door stations are followed by other actions in a Response, then the other actions are not done. Workaround is to place the above actions as the last action in a Response
Actions 35 (Save Last Counter( 37 (Save Last Sensor), 121 (save Input value to sensor), 151 (Initialise Sensor) do not save the correct value
Action 148 Multiply by Constant gives wrong result. But multiply by counter and Multiply by sensor do work
Reminder Enable function does not work for Reminder Numbers 9 to 16. Reminder Enables for 9 to 16 are the same as Reminder 1 to 8. This affects Scheduled Reminders only.
Vocab Upgrade fails during the sentence upgrade process with Error Code 29. If this happens, repeat Sentence Upgrade only, not the full Vocab Upgrade

Note New Action codes are not yet supported in Comfigurator 3.6.4

The firmware can be downloaded from https://www.cytech.biz/comfort_ultra_fir...ory_id=101