Heatmiser UCM

[ident]

The UCM/Heatmiser allows the integration of Heatmiser thermostats, both RS485 and wifi types, with the Comfort integrated Intruder Alarm/Home Automation System.

Update/Warning
Note that only Heatmiser products supporting the V3 protocol are supported by the Heatmiser UCM. The wifi thermostats have been discontinued and are replaced by models which are not compatible
Please check which heatmiser products you would like to work with before deciding on the UCM/Heatmiser


Heatmiser Thermostat shown above


The UCM/Heatmiser has the following functions;

1. allows control and  temperature monitoring of Heatmiser thermostats from keypads, telephone, iPad/iPhone/Android app, SMS (with UCM/GSM), or software.
   
2. allows control of Heatmiser thermostats by Time Programs.
3. allows setting of the alarm to Away, Night, Day, Vacation and Security Off to change heating and cooling setpoints in Heatmiser.

The UCM/Heatmiser comes without an interface, and an interface submodule AUX485 for RS485, or ETH03 for wifi heatmiser products must be addded according to the type of heatmiser to be supported


The UCM/Heatmiser with Isolated Rs485 interface is shown below.






The UCM/Heatmiser with Eth03 interface is shown below




The UCM/Heatmiser manual can be downloaded from https://www.cytech.biz/ucmheatmiser_manual.html

System Requirements

1. Comfort Firmware 7.042 and above
2. UCM for programmming  7.038 and above
3. UCM/Heatmiser 7.038 and above with ETH03 or Rs495 Interface
4. Comfigurator 3.7.8 and above