Comfort Automation/ Security System Forums › Products › UCMs
Upgrading Comfort II Flash firmware by UCM Programming Cable

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Upgrading Comfort II Flash firmware by UCM Programming Cable
slychiu Offline
Administrator
*******
Posts: 5,960
Threads: 872
Joined: Apr 2006
Reputation: 2
#3
01-03-2010, 02:22 AM (This post was last modified: 05-01-2012, 01:12 PM by ident.)
The picture shows Upgrading of a UCM/Cbus using UCM/USB
When the programming cable is connected to the UCM/Cbus,  and the PP2 shunt inserted on the UCM/Cbus, its D9 and D10 leds will flash in time with that on the UCM doing the programming

The UCM/CBUS should  not be connected to Comfort at this time


Attached Files Thumbnail(s)
   
Website Find
Reply


Messages In This Thread
[No subject] - by - 11-02-2008, 07:20 AM
[No subject] - by - 01-03-2010, 02:19 AM
[No subject] - by - 01-03-2010, 02:22 AM
[No subject] - by - 05-31-2011, 11:07 AM
[No subject] - by - 05-31-2011, 12:29 PM
[No subject] - by - 06-28-2012, 04:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)