Connecting from PC to Comfort

[ident]

The photo is of the UCM/Ethernet, not Comfort. You earlier said that the customer may have a UCM01, then you said that he may have a network port so I was trying to establish what is available

The X10 connector is an RJ11 socket, used for the X10 power line  interface

If there is no UCM then you will have to program by keypad, and you will need the Worksheet for File system 18, attached

The numbers on  the bottom of the Comfigurator screen are locations in Comfort, and the values which should be programmed in the locations
Locations can be used to program Comfort if there is no Engineer voice menu to program the  parameter

To access the Locations Menu, go to Engineer menu, ie F0 followed by Engineer Code and # key, then menus 7,4,1 for Locations
Enter Location Number and # key

eg (2153)= 4,85,255

enter 2153# in the Locations menu
The menu will read the programmed value in the location eg 10
\"Enter New Number and # key\"
You enter the number to be programmed in the location eg 4 followed by #

In most situations there is an Engineer Menu to program the item as detailed in the Engineer programming manual