Comfort Automation/ Security System Forums › Products › UCMs › UCM Problems v
couldn't connect to ucm Ethernet

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
couldn't connect to ucm Ethernet
ident Offline
Administrator
*******
Posts: 3,493
Threads: 476
Joined: Aug 2006
Reputation: 0
#2
04-18-2012, 02:54 AM
Was the UCM working befiore upgrade to 6.012?
Is it ETH01 (orange module) or ETH02 (silver)
MJ101 pins 7 and 8 are not connected so iut should not cause a problem

Are D9 and D10 leds  both  blinking?
check the shunts in SW8 - F should be shunted if ETH01 and Not shunteed if ETH02
Find
Reply


Messages In This Thread
[No subject] - by - 04-17-2012, 03:11 PM
[No subject] - by - 04-18-2012, 02:54 AM
[No subject] - by - 04-18-2012, 10:26 AM
[No subject] - by - 04-18-2012, 10:30 AM
[No subject] - by - 04-18-2012, 11:28 AM
[No subject] - by - 04-18-2012, 12:26 PM
[No subject] - by - 04-19-2012, 04:00 AM
[No subject] - by - 04-19-2012, 09:06 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)