10-17-2014, 06:07 PM
Hi Chiu - your suggestion on connecting directly to the PC worked, so I\'m back up and running with all UCMs updated. THANKS! I guess there is a network issue with the router, though I\'m not having any problems with anything else.
In answer to your question, Yes, I did get that message. If I click yes when using the cable method it says it is not supported. When I did that using the network update, I got a subsequent error that DUT wasn\'t present, I then get a message asking to do the update again, comfigurator takes a while to respond but then does the firmware update again from 0% but then same error.
Will there be a firmware update to ETH02 to fix the timout issue or can I assume it is in fact another issue with the router and not dare to try a network update again until I perhaps replace the router?
In answer to your question, Yes, I did get that message. If I click yes when using the cable method it says it is not supported. When I did that using the network update, I got a subsequent error that DUT wasn\'t present, I then get a message asking to do the update again, comfigurator takes a while to respond but then does the firmware update again from 0% but then same error.
Will there be a firmware update to ETH02 to fix the timout issue or can I assume it is in fact another issue with the router and not dare to try a network update again until I perhaps replace the router?