Dynalite Communications problem

[Scott James]

When you have the jumper off, it looks exactly the same as the errors I was getting. Hmmmmmmm very interesting!!!!   It\'s time I do some more testing!!

Thanks for all your help Ian!!

Regards,

Scott James

[NickG]

Hi

I have been setting up a link from Comfort to Dynalite for a customer and have tried both the UCM485 and a UCX/DNG232 approach.

Using the UCM485 it works fine but I\'m getting the same error messages on the monitor so thanks for the info about the jumper on G, I note that this is mentioned in the DNG232 article on the Cytech site but not in the manual for the UCM485, so this needs amending.

Could not get the DNG232 approach to work at all, D12 was flashing on the the UCX but no message was being received on the network. Questions:

1. Do you need a special RS232 cable, I notice that both 9 pin D\'s are female, do we need a cross over cable?
2. Couldn\'t see any setting on the DNG that would change it\'s mode, but was under the impression it should receive the normal Dynet commands out of the box, no one was available in tech support at Dynalite Europe yesterday so wasn\'t able to check this and this is my first experience with a DNG232, so any pointers here would be helpful?

Thanks in advance

Nick

[adlim]

Hi NickG,

Seems like the command works whether the SW8-G is inserted or not, despite the error on the DNG232.

As for the 2 queries:

1) Yes you do.

2) This would need to be amended using the DLight2 software