UCM/ ARM firmware 8.007 to 8.028

[slychiu]

UCMA 8.007  

Bugs

1. If ERR red LED remains on after  reset or power on, it means the wifi submodule has been detected. If  this occurs when USB or eth03 submodule is inserted in CM9001 or UCM,  the ucm will not communicate. If tis happens power off and ON the UCN by  removing and inserting the 4 way cable to the UCM. Similarly if wifi is  inserted in the UCM baseboard the ERR red LED should be on. If it i  not, then power off an on the UCM in the same way
   

New Features and Changes

•  D?0000 queries ARM CM9001 and Slaves for battery voltages and DC voltages. allows Comfigurator 3.14.14 to read Battery ad DC Voltage values for CM9001 Arm processor
  
• TE command to test EEPROM size  TExx where xx = 1 for 1st eeprom, 2 for 2nd eeprom in the UCM. If xx is missing defaults to 1st eepromno xx is 1st eepro. Repies with 08 = 24C256 256KBits size
  

[slychiu]

UCMA 8.028

Bugs Fixed

• fixed bug ETH03 plug in to CM9001 could not read serial numbers
  
• fixed bug for ARM arm keypad user should be F0 instead reported as 96
  
• Bus monitor now should work with no errors
  
• fix BUG s? sensor query  causes endless count
  

Changes and Improvements

• UCM ID A=15 is reserved for upgrader id, if UCM ID = 9 to 14 ie switch D i  OFF, set wifi enable and subtract 8 to get ID = 1 to 8  nd baud rate 38400 for wifi. This means that UCM/Wifi needs to switchSW7 DIP switch 4 (or D) to the OFF position in order to work as ucm/wifi at 38400 baud. wifi is no longer auto detected as the detection sometimes did not work well
  
• message r?nn  if nn no of bytes=0, change to max 16 registers