View single post by The Old Scholar
 Posted: Monday May 6th, 2013 06:36 pm
 PM  Quote  Reply  Full Topic 
The Old Scholar

 

Joined: Thursday Sep 10th, 2009
Location: United Kingdom
Posts: 14
Status: 
Offline

  back to top

I used Comfigurator 3.6.8 and selected the modules tab as you describe. I have used this method several times before and not had any problems, other than the occasional fail, but it has always worked when I have then tried again.

If I try to connect via Comfigurator now I get the 'Failed to connect to UCM' error every time.

I am in the process of ordering an additional UCM with RS485 plug in. Will I be able to plug the ETH02 module into the new UCM and use that with a programming cable to reload firmware onto the corrupt board?
 Close Window