View single post by The Old Scholar
 Posted: Friday May 10th, 2013 12:13 pm
 PM  Quote  Reply  Full Topic 
The Old Scholar

 

Joined: Thursday Sep 10th, 2009
Location: United Kingdom
Posts: 14
Status: 
Offline

  back to top

I am trying to connect the UCM/Eth02 to Comfigurator. The firmware upgrade was underway, but it failed and I have double checked the settings once again and they are fine.

I am buying UCM with RS485, which I can see from your note below cannot be used to reload firmware onto the UCM/Eth02. Is there any other method I can use to reload firmware onto the UCM/Eth02 or can I send it somewhere to have the firmware reloaded?
 Close Window