back to top

• Virtual node counter update triggers Comfort Response, even if the value is unchanged so Scene commands can work.
• Improved EEPROM write cycle during Learn mode.  Previously, it did not respond to Poll command during write.
• Backup Z-Wave data block in case of learn failure[size=,]which causes it to reset and all virtual nodes lost. This workaround is recommended by Z-Wave.  In event of failure, data block is restored to same network ID and node ID. If the controller is not in network before learn, the backup will not be initiated.
• EEPROM is updated automatically, after virtual node is added or removed.  Hence, no need to "learn" from Primary Controller again.
• UCM/Zwave Learn mode time-out increased to 60 secs.  This caters for cases where learn error happened, but user is unaware and keeps waiting for completion.
• Automatic "factory default reset" when controller is excluded from network. Added new auto report status when UCM source 1D is available.
• Cater for Multilevel switch command class. Status report value cannot be 100(Ox64) to 254(OxFE). If value falls in this forbidden range, will report as 255(OxFF) instead.
  
• During learn, controllers are polled for supported command classes as well.
• Patched Multilevel Switch Report Command.  Previously, registers are not updated correctly[size=.]
• Inhibit Z-Wave commands to send to non-existing nodes or channels in nodes. Also inhibit Z- Wave commands sending to non-supported nodes.
• Inhibit Z-Wave GET commands for multichannel bit address (ie. requiring reply from destination).
•  Add new status to indicate when response commands are inhibited.