| PM | Quote | Reply | Full Topic |
| Joined: | Wednesday Aug 9th, 2006 |
| Location: | Singapore |
| Posts: | 3493 |
| Status: |
Offline
|
The KT03 Thermostat 1 page is seen below(in KT03 simulation Mode)
Touching the On/Off button will toggle the On/Off state by toggling the assigned flag
The temperature box shows the value of Sensor 1
The Cooling and Heating Setpoints (counter values) are shown. The + and - buttons below the heating and cooling setpoints increment and decrement the heating and cooling setpoint counters.
The Heating and Cooling Boxes show the state of the respective Outputs.
The + and - buttons next to the temperature display is to simulate the temperature to see the effect on the heating and cooling. Use this to increment and decrement the sensor holding the temperature and see the heating and cooling outputs turn on and off accordingly. These boxes can be deleted in the final configuration.
The KT03 can fully simulate the action of the thermostat without connecting any hardware
If only heating is required set the cooling setpoint counter value to 0.
If only cooling is required, set the heating setpoint counter value to 0.
| Close Window |