alvy
Joined: | Friday Jan 18th, 2013 |
Location: | |
Posts: | 17 |
Status: |
Offline
|
back to top
|
ident wrote: If you still have many nodes as basic after a learn, it may be the last node which is a dimmer which is causing a problem on the zwave network
Exclude it and see if there is any problem
The last node which is a DIN module dimmer is also directly associated to a satelite switch via the same remote so that it can be controlled by that switch. I did a series of other association with other switches to establish some 2 way switching before i let the ucm learn the network again which included the last node addition. Can this cause the problem mentioned? But then, before i attempted the reset earlier, during the 1st round after i upgraded the firmware, i used the remote to incl all switches in one go before i replicate to the ucm. Already without setting associations all nodes are detected as basic. Very puzzling..
|