Comfigurator 3.8.8 is available
Please upgrade to Comfort firmware 7.057 (or above), as older firmware may have extra keypads 9 to 15 appearing after a scan
This mainly fixes some bugs
Known Bugs
- Cbus1 actions which are not in the Lighting application are not converted correctly to Cbus2
- Extra keypads 9 to 15 may be detected after a scan using Comfigurator 3.8.7 to 3.8.8. This happens if the scan is done after initialisation. Go to File > Update Defaults to update the default files (This needs an internet connection) Also you can upgrade to ULT 7.057 which does not have this problem
- RIO Input and Output status are initially shown by checking the "show status" box, but subsequent changes in RIO input and outputs are not updated
- User Mode > Dial Test does not work if the keypad name is changed. The old keypad name is used in the dial test so cannot be found
- Options > Default KT03 Template causes an exception
- Function Blinds > Show References do not work
- Keypad volume change does not get selected in "Selective Write".
- Lutron commands for use in General and Universal UCM have error when more than 1 control Unit is specifed
Bugs Fixes
- Fixed Bug where ucm/Cbus1 upgraded and converted to UCM/Cbus2 may cause Comfigurator to give a message that "Cbus1 actions have been converted to Cbus2 actions" even though the actions have already been converted to the new UCM/Cbus2 format
- Fixed Bug from Comfigurator 3.6.5 where Read User Codes did not work
- For UCM/Cbus2, Importing a cbz file caused duplicate group addresses to be imported. Now there will be a popup box allowing selection of one Cbus network only
Last edited on Monday Jul 7th, 2014 08:12 am by ident
|