View single post by Vangelis

Posted: Tuesday Feb 17th, 2015 03:23 am

Joined:	Tuesday Jan 31st, 2012
Location:
Posts:	138
Status:	Offline

OK so I am trying to emulate Henley's idea of having Comfort talk to my HA system through it's TCP connection, however I am not having much luck in getting Comfort to talk via the Serial Commands...

I have Comfort Ultra 2 with UCM/Eth2

Tried...

Comfigurator - this works and I can see the Serial cmds go back and forth in the viewer

Telnet to Eth2 IP port 1001 - Get connection but cannot see anything, no output is echoed to screen

Use ClearConnex - Not sure if I am using this correctly. I can establish a connection, however I am not sure where you type the cmds?? Either in the main window, or in the small window at the bottom?

Either way, I can see no output - have setup a hotkey for /03. The only output I get is when Comfort decides it's had enough and closes the connection and displays LU00 (even when I haven't typed in anything)

So not sure where I am going wrong as it all worked for Henley, when he added the magic /03 to his Lixxx cmd to login. Is there a time period when Comfort expect a cmd??

Can I just fire up the connection and enter /03LI1234 in the small window at the bottom of ClearConnex (where 1234 is my code)??

Vangelis

Close Window