| Full Topic |
| Joined: | Saturday Mar 3rd, 2007 |
| Location: | Singapore |
| Posts: | 1200 |
| Status: |
Offline
|
The buttons "Local, Remote" will allow you to switch between "Local" and "Remote" without entering Setup page.
Take note of the text "Connected" below the setup and log-in buttons.
"Connected" means that the app is able to connect to the UCM/ETH03. The Login button can be selected only if the status is "Connected"
The profile selected is also shown below and local or Remote connection.
eg "Home@local" or "Office@Remote
If it is not able to connect, the status will show "connecting.." or "not connected" or "data error". "Connecting" means the port is busy ie there is another connection or there is a network problem. "Data Error" probably means that IP address is incorrect
Press the Setup button to go into the setup page.
The IP Addresses and Port numbers for Local and Remote are taken from the cclx file. You can change the IP addresses and port here, or preferably enter these in Comfigurator and re-export into the app.
Select either Local or Remote.
"Local" means you are connected by wifi to the same network as the UCM/ETH03
"Remote" means you are connected by Internet. This requires port forwarding on your router.
The password can be saved (under "demo.dyndns.org" above). If the password is saved here, you will not be required to enter password when you press log in button in LOCAL mode. In Internet mode, you will be required to enter the password.
You can go to Camera Setup page by clicking "Camera" icon (circled in red) on the setup page.
On the Camera side, select "InApp", "Basic", or Pro"
InApp means you can view the camera inside the app provided the camera is in the list of models supported. More cameras wil be added for in app support in future
"Basic" and "Pro" means that one of the 3rd party apps IP Camviewer Basic (free) or IP Camviewer Pro (paid) are used to set up and show the camera. This means that the 3rd party app will take control when you wish to view one of the cameras.
If you select InApp, up to 4 IP cameras can be set up. Select the Camera 1 to 4 and select the Brand and Model from the drop down list. Note that there is a limited set of cameras which are suported in App.
Enter the IP address and Port of the IP camera, and the user name and password for the IP Camera. Check the box "Follow Comforts Remote setting" if the Internet IP address for the camera is the same as that of Comfort (which is normally the case unless the camera is on another network or another site). You can view "Follow Comforts Remote setting" by scrolling down the camera setup page.
Then press "Update>>Done" to finish setup.
| Close Window |