View single post by Vangelis | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Thursday Aug 27th, 2015 03:28 pm |
|
||||||||||||
Vangelis
|
Hi all, I tried (and failed) with the UCM/ZWave module - mainly as I misunderstood the concept of it's workings... So I now have UCM/Eth2 interaction via serial cmds working, and was wondering if I could do the following...? I have a ZWave door sensor on the front door, and want to have this trigger the entry / exit delay of Comfort. This currently reports it's 'state' to my HA and I can have this issue a Serial cmd to Comfort - bit I am unsure about is what cmd to issue (basically simulating the activation of a virtual entry/exit zone via serial cmd) Any ideas? Vangelis
|
||||||||||||
|