View single post by slychiu

Posted: Thursday Aug 27th, 2015 04:26 pm

Joined:	Saturday Apr 29th, 2006
Location:	Singapore
Posts:	5498
Status:	Offline

If you have UCM/Zwave3, this can be by done by creating a virtual node associating the Door sensor to it, and mapping to a Virtual Zone.
The door sensor becomes a virtual Input say Zone 1. Program Zone 1 as Entry Door zone type. When the door sensor opens, this will start an entry delay just like a physical zone.
Virtual Inputs are possible by KNX and Cbus UCMs where group addresses can be mapped to virtual nodes

With UCM.ETH and without UCM/Zwave this is difficult

One roundabout way is to connect an unused Output eg Zone 10 in Comfort to a Zone Input programmed as Entry Door. Send the command O!0A03 to Pulse Output 10 for 1 second (ie open and close the door)
This will start an entry delay

Close Window