View single post by lwillerton
 Posted: Tuesday Oct 18th, 2016 09:07 pm
 PM  Quote  Reply  Full Topic 
lwillerton

 

Joined: Sunday Oct 2nd, 2011
Location:  
Posts: 221
Status: 
Offline

  back to top

Hi All,

I have been looking at this again and an struggling to see what parameters to set.


The instructions suggest

2) 2. As described in pt. IX IN/OUT mode allows for configuring each IN/OUT independently.
Fig 3 shows an example configuration: I1 configured as a light intensity sensor; I2 configured as a dimmer, e.g. controlling LED strip; I3 configured as a temperature sensor; I4 configured as a dimmer, e.g. controlling halogen lamp.
As shown in Fig.3 inputs set to work in analog mode require following configuration:
- Actual voltage range (e.g. 0-10V, 1-10V, 0-5V)
- Measured unit range (e.g. 0-50oC for temperature sensor)
Above information can be found in sensor's operating manual.
Device icons in the main controllers interface will reflect the above configuration settings, e.g. light sensor, temperature sensor, two OUT devices i.e. LED strips or Halogen bulbs, as shown in fig.4.


IX IN/OUT mode - 0-10V inputs, PWM outputs
Fibaro RGBW Controller has 4 controllable, analog inputs I1 - I4, allowing for 0-10V analog signal interpretation. This functionality may be used in operation with analog sensors and potentiometers. What's more, in IN/OUT mode all inputs and outputs may be configured independently, e.g. I1 may be configured as 0-10V sensor input and I2-I4 may control LED strip or Halogen lamps. Another option is to configure I1 as 0-10V input and connect 0-10V potentiometer to it, and connecting Halogen lamps to R output. At the same time, other inputs may work with 0-10V sensors.

Think I need to set parameter 8 to 1 (mode 2) but not sure.

Attached is a file I found of recommended settings for the fibaro rgbw.

Has anyone setup this device to allow comfort to control inputs via counters? or got any advise on how to do this? My main controller is vera lite.

Cheers

Lee

Attachment: recommended associations settings.pdf (Downloaded 3 times)

 Close Window