| PM | Quote | Reply | Full Topic |
| Joined: | Friday May 2nd, 2008 |
| Location: | West Sussex, UK |
| Posts: | 64 |
| Status: |
Offline
|
UCM02 is part of a Vera Edge network and UCM03 is part of a Fibaro network. Both UCMs have learnt the devices in their respective networks and those devices correctly appear in the Z-Wave mapping screens in Comfigurator Modules.
When I try to write a response to perform a basic get or set command for a Z-Wave device, if the UCM Name is set to UCM02 (default) then the Devices that appear in the Device IDs pop-up are correctly the ones for the UCM02 network. However, if I change the UCM Name to UCM03, then the devices that appear are again the UCM02 network devices, not the UCM03 network devices.
I can work round the problem by adding a command for UCM02 then manually editing the response or the action codes changing the UCM number and the deviceID but clearly it would be nicer if Comfigurator displayed the correct Device IDs.
I am using Comfigurator V3.11.10.0
| Close Window |