View single post by slychiu | |||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Posted: Friday Feb 17th, 2017 06:21 am |
|
||||||||||||
slychiu
|
Yes the change in state of the virtual node is discovered by a zwave controller via polling But if it is not a virtual node, ie if the zwave node is mapped to counter or flag, then changing the counter ior flag immediately sends the command to the mapped zwave node. It has the same effect as using a response to send the command to the node For your application ie sending to zwave when it is dark, you do not nbeed to use a virtual node, just ,ap to Sensor in Zwave to Comfort Virtual Node is for sending commands to Comfort I hope this is not too confusing
|
||||||||||||
|